Tamko Gutter Replacement in Miami, FL

Tamko Gutter Replacement: The Miami Owner’s Guide

We stock and install Tamko-compatible gutter replacement systems in Miami, with typical installed pricing running $8 to $14 per linear foot depending on profile and fascia condition. Most residential jobs run same-day once we confirm the profile match, and we carry the common Tamko brackets, hangers, and downspout connectors on every truck. Homeowners usually notice the problem first during one of our summer downpours: water sheeting behind the gutter, a sagging run that pools instead of drains, or a corner seam that’s started weeping onto the soffit. In Miami’s climate, galvanized hangers give out in 8 to 12 years, and the hidden bracket systems Tamko specified on several 2000s-era installs are particularly prone to corrosion where the fascia meets the stucco drip edge.

Call (855) 837-1678

Which Tamko Models This Applies To

Tamko’s gutter program has shifted over the years, and the part you need depends on when your system went in. The early 2000s “StormRunner” branded gutters used a proprietary hidden hanger with a 5-inch K-style profile and a .032-gauge aluminum that was lighter than what most Miami contractors stock today. If your home was built between 2004 and 2012, check the inside face of the gutter for a small embossed “TAMKO” stamp near the downspout outlet. No stamp usually means a generic install by a builder who spec’d Tamko roofing but not Tamko accessories, which is common in Cutler Bay and Homestead tract builds from that era.

We’re an independent service provider, not affiliated with Tamko, but we source OEM-compatible components and match profiles precisely. For the StormRunner series and later “Heritage” gutter lines, we stock both the original-style hidden brackets and the more robust fascia-mount hangers that most Miami homeowners end up preferring after their second replacement. The critical measurement is the back flange height: Tamko’s 5-inch K-style used a 1-1/4 inch flange, while standard aftermarket is 1 inch. Mix those and you get the wavy, poorly seated runs we see too often in Coral Gables renovations.

Signs Your Tamko Gutter Replacement Is Failing

• Water streaks on the fascia board. This means the gutter has pulled away from the house or the end cap seal has degraded. In Miami, UV exposure breaks down the sealant Tamko used on pre-2010 systems faster than the national average, and once water hits the fascia, you’re looking at wood rot in two to three rainy seasons.
• Sagging between hangers, especially on runs over 20 feet. The hidden bracket systems rely on a single screw into the fascia, and in older Miami homes with soft pine fascia, that screw strips out. You’ll see a belly in the gutter that holds water and breeds mosquitoes, which is more than a nuisance in a county that monitors for Zika.
• Overflow during ordinary rainfall, not just storms. This points to internal downspout blockage or an improperly sloped run. Tamko’s original installs in Pinecrest and Palmetto Bay were sometimes set dead level to hide the slope from street view, which looks neat until the debris accumulates.
• White, chalky residue on aluminum surfaces. That’s oxidation from salt air, especially within a mile of Biscayne Bay. The .032-gauge aluminum Tamko used on budget lines simply doesn’t hold up to our coastal environment the way .040 or heavier does.
• Separating seams at corners or end caps. Thermal expansion in Miami’s 90-degree daily swings stresses caulked joints. Tamko’s factory-welded corners hold better than field-sealed, but many Miami installs used snap-together corner pieces that fail predictably after a decade.

Replacement Cost & What’s Included

For most Miami homes, Tamko-compatible gutter replacement runs $8 to $14 per linear foot installed, with the variance driven by three factors: fascia condition (soft or rotted wood adds $3 to $5 per foot for repair), single-story versus two-story access, and whether you want standard .032 aluminum or the heavier .040 we recommend within five miles of the coast. Downspout replacement adds $45 to $85 per run depending on length and whether we need to reroute around a patio or walkway.

Our quote includes removal and disposal of the old system, new hangers spaced 18 inches on center (tighter than code, but we don’t trust Miami’s wind loads any more than we have to), sealed corners, and alignment to drain properly. Everything is covered by our 90-Day Done Right Promise. If it is not right, we make it right. No paperwork, no arguing. The number on the estimate is the number on the invoice.

DIY or Call Us?

There’s a safe middle ground here. A homeowner can walk the perimeter and note where water flows, where gutters sag, and whether downspouts are clogged with the helicopter seeds that blanket Miami every spring. A garden hose and a steady ladder will clear most blockages.

But ladder work on a Miami roofline is where DIY turns costly. Our crews are trained for the pitch, the sudden afternoon rain that makes shingles slick, and the wasp nests that colonize eaves in Coconut Grove and the Roads. We’ve also seen homeowners buy standard 5-inch K-style from a big-box store only to discover the flange mismatch once the old gutter is off. If you’re up on a ladder with a gutter half-removed and the afternoon thunderstorm rolling in, you’re not saving money anymore. Call us at (855) 837-1678. We’ll sort out the profile match and get it handled in one visit.

FAQs